Showing posts with label fuel pump. Show all posts
Showing posts with label fuel pump. Show all posts

20 July 2013

Time moves in one direction, memory in another.





Looks like the fuel pump won the battle.  I was expecting the box from Germany to arrive today-rather I received the box with the fuel pump.  It's a 'win' either way, really, because I got a box I was waiting for...and the other one should be close behind (Monday, perhaps?).

It's very nice now that I have it-and it's not a Pierburg-it's made by BOD in Italy.  Can't say I've ever seen one before now...It's very similar to the Pierburg but the top is different-it's more bell shaped whereas the Pierburg is more flat on top.

This one has slight corrosion on the front plate but I'm pretty sure I can replate it without any issues.

30 June 2013

"Life is a succession of lessons which must be lived to be understood."

I bought the pump.  It was a bit more expensive than I realistically should spend but I also know that NOS fuel pumps are fairly rare birds...so why not when I have two within reach?

It's going to The Netherlands, where it'll be picked up by a friend and brought back to the US in September.






 This is a NOS hood beak I also picked up.  It has faint scratches from shelf wear but it appears to be in otherwise excellent condition.  This too will find its way to The Netherlands for future transport in September.

Looking at the back side, it appears to be similar to the one that came off of the 64.  The one from the 65 is different in the way it mounts to the hood.

26 June 2013

Cure for an obsession: get another one.

I have one early fuel pump after a repair.  I bought a second one (NOS) and today found this third, also NOS, fuel pump today.  I'm on the fence about buying it...but I'm compelled to do so.

I also found two NOS distributors that I should be receiving in a few weeks.  That'll put me up to four ZV JCU 4R3 distributors, two of which are NOS.  I think this just goes to show that the parts are out there once I figure out where to look.

I found a NOS left door seal and a second NOS rear hatch seal, along with a windshield seal.  I'm guardedly optimistic about the windshield seal but I hope that it's in excellent condition...the NOS seals fit better than the repops out there currently.

I'm done with ignition columns and finally pared down the collection to a reasonable quantity...so it's only fitting, I guess, that I move on to distributors and fuel pumps.  I'll get the distributors down to three (I'll sell the T34 specific unit eventually).  Actually, I'll probably get everything to threes-one for each engine and a spare.

This, of course, means that it's time to sell off some parts.


The first pump arrived back at the house today after a trip to sunny Southern California for a rebuild and clean up.  The lever is now new, properly greased and the pump is ready for action.

23 June 2013

“Better to die on one's feet than to live on one's knees.”

The fuel pump I purchased has been repaired and is on its way back to me in the next few days.  I'm now considering building up another 1500 S motor since I have the short block and most of the parts to do so...and the parts I don't have - I know where to find them.  Hmmm...maybe instead of that monster motor, I'll just build another 1500 S and sell off/trade the later case.


Further information from Pedro Sainz explains that there are two versions of the internal actuating lever for this fuel pump:  -62 (left side) with a larger diameter spring and lever and the 62-65 with the longer, smaller diameter spring and single piece lever.  Fortunately mine was just 'late enough' to be the one on the right because parts are more plentiful.

I also went out to visit Steve and check on the progress thus far...


Ferris is upside down on a rotisserie with the outer rocker skins cut off.  The rockers are almost as bad as those on the red car.  The entire inner heater channel piece is going to have to be fabricated-the inner and bottom are completely gone.  The pipe for the wiring harness was also broken/split so if the rockers hadn't been opened up, I never would have managed to get the new harness into the car because it was so mangled.

Most of the work will be done in the Fall...initially I was a little disappointed by that news.  Then I realized that will buy me enough time to build up the engine/rear suspension, have the front beam done and most of the 'expensive' stuff done by the time he really starts digging into the job.  The rockers/heater channels are the worst part.  There's a little work behind the B pillar, a small hole in the cowl and the rear drain flap area then the body is 99% done/ready for paint.

I was a little bummed out to see that the car is going to need so much work - but once it's done, I'll know that it's completely done and done correctly because it's all been opened up and fixed.

I won't be driving this car to the Type 3 Invasion...and in all reality I won't be going to it at all.  I'd rather go to the Classic next year and the two events are 3 weeks apart.  I don't see me going to both events given all of the other things I have going on...

19 June 2013

Expectation is the mother of all frustration.

I received the fuel pump I bought a few days ago.  I discovered that the shipping cost I paid was for Standard Post shipping rather than Priority Mail, which was both cheaper and faster.  I opened the box to find that it's in fairly rough shape.  I'm trying to get that sorted shortly.  Money spent but not spent well.  It'd be great if people could just be honest and straightforward... but that's probably asking too much.  Is it a 'game changer'?  No, but it's yet another disappointing reality of this hobby.  A lot of people will fuck you if given the chance.  I've got to stop dropping the soap, so to speak...

I have got to stop being so optimistic about things until they're actually in my sweaty little hands.  I got a lot of shit for being cynical but I was disappointed far less often when I took that view of things.

It was a rough day all around today and I probably should have called in sick and played video games or cleaned the garage (two forms of 'therapy' for me).

News of the engine rebuild will come tomorrow-looking like it'll need a bit more work than expected but it should still be relatively affordable. (here I go being optimistic again...)

13 June 2013

“Supposing is good but finding out is better.”

I got a little education today about fuel pumps for my 1500 S motor from Pedro Sainz.  The two in the left side photo on the dirty table are mine.  The right side is a NOS Brazilian pump and the left is the one that came off the 1500 S motor in question.  The body of the no name fuel pump belongs to a Type 2, according to the number stamped on the back of the pump, although it is possible that the tops were swapped.  The outlets are not totally correct (notice the difference between the tube orientation between the units in the two photos).

The right side photo is a rebuilt early Type 3 fuel pump that I just bought.  It was pure dumb luck that I found it when I did.  They don't come up very often.  I must have looked at just the right time.

The photos below shows a mostly stock engine with the correct fuel pump installed.  I *think* the top photo is of Scott's old Variant and the bottom photo is of the engine in Pedro's car.  I'm not 100% sure, however, so don't quote me on it.




So the good news is that I found the right fuel pump...and I have a few to sell in an effort to reimburse myself for what I've spent on fuel pumps.  The bad news is that I spent money on the wrong thing.

An education is costly sometimes...but it's money well spent if it doesn't get spent again.